READ ALL OF THESE DIRECTIONS FIRST!

Clean the surface well to avoid dust and oil under the vinyl.

Without removing the backing, place sign exactly in the position it is to be displayed and use small pieces of masking tape to temporarily keep it in place.

Step back and see how it looks. Remember, that once it’s been applied, it cannot be repositioned.

Measure twice to assure accuracy, measure from the flat areas on numbers and/or letters.

Apply a masking tape across the entire top edge to make a hinge.

Fold the sign up along the tape hinge.

Remove the backing (back side), revealing the sticky side. (Only remove the backing - DO NOT remove the transfer tape/front side)

CAUTION: Do not allow the sign to fall freely on the surface or it will stick there and potentially ruin the vinyl if you try to remove it.

Hold the bottom of the sign away from the surface. Carefully begin to squeegee down the top 1 to 2 inches along the top edge.

Work from the hinge down, squeegeeing down and out over the entire sign, but be careful not to trap any air bubbles behind the vinyl.

Remove the transfer tape by slowly peeling it back from the sign at a sharp angle.

The sign will remain in place if it has been firmly applied. If any air bubbles appear, flatten them with your finger or puncture with a pin and squeeze the area to release the bubbles.

CAUTION: Once the sign has been applied it cannot be repositioned.

Lastly, once the vinyl is ready to be removed, simply peel it off. The sign is not reusable once removed